Single Malt Scotch Whisky production
3. Milling

  • Single Malt Scotch Whisky production<br>3. Milling image 30278
  • Single Malt Scotch Whisky production<br>3. Milling image 30282
  • Single Malt Scotch Whisky production<br>3. Milling image 30283
  • Single Malt Scotch Whisky production<br>3. Milling image 30285
  • Single Malt Scotch Whisky production<br>3. Milling image 30287
  • Single Malt Scotch Whisky production<br>3. Milling image 30288
  • Single Malt Scotch Whisky production<br>3. Milling image 30289
  • Single Malt Scotch Whisky production<br>3. Milling image 30290
  • Single Malt Scotch Whisky production<br>3. Milling image 30292

Words by:


After malting, the malted barley, which is as crispy as well-done toast, is milled into powder known as ‘grist’. The consistency of this grist is crucial to the extraction of fermentable sugars during the next stage – mashing.


Two traditional makes of mill resembling museum pieces remain almost universally used by Scotch malt whisky distillers - the commonplace 'Porteus Patent Malt Mill' and the rarer Robert Bobby Mill. Modern milling machines are quicker but distillers prefer the old British engineering of the Porteus mill due to its reliability.

ency 58 image
Porteus mill at Craigellachie


ency 69 image
Bobby mill at Ardbeg

Before entering the mill the grain first passes over vibrating screens to separate and remove stones and other foreign bodies which could damage the mill.

ency 85 image
Destoner at Macduff

Inside the mill, two sets of rollers crush the grain - the first pair of rollers crack open the grains then the second pair, which are adjustable, grind the grist to the consistency best suited to a distillery's mash tun. The consistency of the grist is assessed by separating and measuring the three component parts of the grist. The optimum consistency for most distillers is 20% husk (coarse) 70% grits/heart/middles (medium) and 10% flour (fine). However, some prefer 15% husks, 80% grits and 5% flour.

ency 65 image
Roller setting on a Porteus mill

It is important that the consistency of the grist is correct for maximum extraction of fermentable sugars during the mashing process. If the grist has been milled too finely, then water will not pick up soluble sugars, while if it is too coarse the water will run though.

ency 50 image
Shuttle box

The consistency of the grist is tested using a wooden shuttle box within which are three layers separated by two sieves, each with progressively finer mesh. Grist is placed on the top layer of the box with the largest mesh base, the box is closed and shaken from side-to-side - hence the name 'shuttle box'. When the box is opened the husks will be trapped on the top layer, grits in the middle layer and flour on the bottom of the box. Each part is then weighed and the percentage consistency calculated. The mill rollers will then be adjusted accordingly to produce finer or courser grist.

ency 81 image

Continue reading: 4. Mashing...

×
  • Welcome to
  • Receive updates packed
    with drinks, bars and
    cocktails content
  • Please confirm you are over 21 years old and enter your email
  • No thanks, continue to diffordsguide.com
CSS revision 1474019063